Stone carving machine should be cleaned up frequently and lubricated with oil in normal use. Otherwise, when relief engraving machine runs for a long time, there will be quite a lot of dust impurities inside the screw, guide rail and bearing. Bearing rotational resistance is large, there will be a slightly faster engraving speed will appear the phenomenon of step misplacement.

Technicians found in the after-sales and inspection process, many people who used woodworking engraving machines think that stone carving machines do not need to be cleaned so clean, or basically do not need to be managed. When they are in use, just clean the table properly. Why? Because they all think that the woodworking engraving machine itself has a lot of dust, that is to say, he is in the dust itself. If we clean up the things we use every day, how troublesome it will be. So many people not only do not clean up, but also let the machine be full of things. This is wrong. The correct way is:

1. Clean up the desktop in time after work, which provides convenience for the next work.

2. Clean up the material debris beside the guide rail to prevent the machine from jamming in the working process due to debris interference.

3. Clean the lead screw regularly to prevent foreign bodies from sticking on the lead screw. The lead screw is very important in the equipment. It determines the accuracy of the machine, and the lead screw plays an important role in the transmission process.

4. Clean the industrial control box regularly, the biggest killer of PCB when dust.

The maintenance methods of the guide rails of such engraving machines as advertising engraving machines, woodworking engraving machines and processing centers are as follows: the X, Y and Z axis guide rails should be cleaned after each operation, the chip and dirt on the track should be cleaned up, the scratches and damages on the guide rails should be checked, and lubricants should be added to the guide rails after cleaning, so as to facilitate the next day's operation. It is the first step to prolong the service life of the engraving machine.

The common maintenance method of stone carving machine track: Because stone carving machine often uses water, so the machine is relatively humid, it must be daily maintenance of the track. When maintaining, we must pay attention to the maintenance of oil for X, Y and Z three-axle rods; high-speed butter must be used for the screw part; in winter, if the working environment temperature is too low, the screw rod, light rod, square guide rail or circular guide rail should be washed and cleaned with gasoline before adding oil, otherwise it will cause excessive resistance in the transmission part of the machine and lead to machine dislocation, etc. Problems arise.