First of all, look at the characteristics of the single arm combined stone sawing machine. The frame of the single arm combined stone sawing machine is connected with two-way separate cantilever on the rigid frame column. There are lifting arms at the cantilever end, diamond disc saw at the lower end of the lifting arm, spindle drive motor at the top, vertical lifting screw in the lifting arm, and speed regulating motor in the feeding vehicle. The advantages of single arm combined stone sawing machine are: small size, light weight and large input torque; single-arm or double-arm sawing operation, simple structure and flexible operation; circular saw can have three rotational speeds, feed truck can speed up, and can meet the needs of different hardness of stone sawing speed. It is suitable for the sawing and cutting of various stone materials.

The feed screw of the worktable car of the single arm combined stone sawing machine is equipped with protective device and clearance adjusting device, which greatly improves the service life and slicing accuracy of the screw. The cycloidal pin reducer is used to drive the lifting screw to use saw blade for lifting and lifting, which is convenient for maintenance and low failure rate. The latest four-column hydraulic lifting can also be selected, and the lifting is stable and fast. It combines the advantages of large saws and cutting machines, with high efficiency and low consumption.

In the process of using the single arm saw, the following operating procedures and specifications must be paid attention to. Here is a brief introduction .

1.Machine installation must be stable, grounding wire or power supply through leakage protector must be provided, cutting stone without adding water is strictly prohibited.

2.It is strictly forbidden to press the button of both input and return parts. After the work is finished, the residual rock slag on the working table should be cleaned and the water on the blade and the working table should be wiped clean.

3.Clean the advance and retreat guide rails and screw of the worktable and apply lubricating oil. Butter oil is added regularly to the spindle, screw shaft and transmission axle at both ends.

4.After the whole machine is used, if it is not used for a certain period of time, the moving parts of blades and fixtures and some rusty parts in the machine should be coated with anti-rust oil.