First, you need to read the instruction manual of the stone cutting machine motor, and clearly understand the performance and function of the engraving machine motor. One of the key parts is the engraving head motor of the engraving machine, because the engraving head motor is not included in the machine warranty. Within the scope, plus the engraving head motor is running around the clock, so if the engraving head motor is different, it will seriously affect the operation of the engraving machine.

Second, because the engraving motor of the engraving machine is divided into two types, the power of the stone cutting machine must be clearly understood. There are some less powerful engraving machines that can only be used to do some simple material processing, so the process has been popular for a long time, but because the engraving power is too small to reduce its scope of use. Compared with the low-power engraving head engraving machine, the high-power engraving head engraving machine is divided into two types, one is a large-format cutting machine, the distribution area is more than one meter, but one disadvantage of this engraving machine is its precision. The degree is very poor; the other is the more suitable engraving machine, its accuracy is much more accurate, suitable for fine processing.

Third, it is necessary to pay attention to the range of speed selection of the engraving machine motor. Under normal circumstances, the speed per minute cannot exceed 30,000 revolutions. If the speed cannot be adjusted or the range of speed can be selected is small, then it is seriously restricted. The range of use of the engraving machine, because the engraving machine needs to use engraving heads with different rotation speeds for different materials.

Fourth, the operation of the engraving machine is controlled by the controller. In general, it is divided into two types. One type of controller is used for driving. It is all computerized to complete all its calculations. It is relatively fixed. The operation mode, so in the process of the engraving machine work, because the computer is in a waiting state, the typesetting work cannot be completed. Another kind of controller is operated by a single board computer or a single chip microcomputer. This is equivalent to one computer being operated. Therefore, as long as the engraving machine runs and the computer immediately processes other typesetting processes, this controller is especially suitable. For a long time of engraving work, the effect is more prominent.